Using the truth table below predict what the output would be for an AND gate and an OR gate if the input A signal is 0 and the input B signal is 1.

Identify the scale that reads 1 inch on the drawing = 100 ft. actual.

Using the diagram below identify the position of the valve.

Using the diagram below identify the type of control valve shown.

Using the diagram below identify the valve actuator type shown.

The revision block on a drawing represents changes made to the drawing.

Isometric projections presents a single view of the component commonly from above and at a 30 degree angle.

Identify which of the designations represents a pneumatic to current modifier.

Logic AND gates provides an output (on) when all its inputs are on, true or equal to 1.

Using the diagram below identify the pipe fitting shown.

The drawing shown below is an example of what type of drawing?

Transmitters are used to convert the signal from a sensor to a form that can be sent to a remote point for processing, controlling, or monitoring.

Using the diagram below identify the electronic component shown.

Using the diagram below identify the component represented.

Using the diagram below identify the electrical component shown.

As a rule P&IDs do not have a drawing scale and present only the relationship or sequence between components.