• True
• False
• #### 2.  A Line drawn with a long section, short dash, and another long section is a __________

• hidden feature
• center of a circle
• center axis of a hidden cylinder

• 1.906
• 4.7625
• 5.959
• 14.6844
• #### 4.  Some traditional board drafters preferred the drafting machine over the parallel straight edge because it could be used without the need for ________.

• circle templates
• triangles
• technical pens
• lettering guide

• True
• False
• #### 6.  An Engineer's scale would be used to measure lines on a drawing where the scale factor reads ________

• 1/4" = 1'-0"
• 1/8" = 1' -0"
• 1"= 100"
• 3/4" = 1'-0"
• #### 7.  In order to convert fractional inches into decimal inches _______.

• look on metric conversion chart
• divide the numerator (top number) by the denominator (bottom number)
• check the engineer's scale
• all of the above
• #### 8.  Several of the tools used in traditional drafting include the following:

• parallel straight edge
• 45 degrees triangle
• circle template
• all of the above

• True
• False
• #### 10.  Traditional drafters need to be able to create several different line widths because _______________.

• different line widths convey different information
• the line width has to do with how dark it appear in the finished drawing
• they seem to transmit better in a fax machine
• it makes no difference

• True
• False

• 360
• 180
• 270
• 310
• #### 13.  A civil engineer working on a bridge design would probably rely on his _______ scale for checking printed drawing.

• Engineer's
• Metric
• Architect's
• None of the Above
• #### 14.  The first step in creating a traditional technical drawing is to _________.

• draw a series of guides lines
• set up the miter line
• align the paper so that it will be positioned square to the parallel bar
• sharpen the leads in the technical pens
Report Question
access_time